How To Break Up A Cast Iron Tub

Cast iron tubs are durable and can last for many years, but they can also be very heavy. If you need to break up a cast iron tub, there are a few things you can do to make the process easier. You can use a sledgehammer to break the tub into smaller pieces, or you can use a drill to drill holes in the tub and then use a crowbar to pry it apart.

How To Break Up A Cast Iron Tub

Cast iron tubs are known for their durability and longevity. However, at some point, every cast iron tub will need to be replaced. The process of breaking up a cast iron tub can be difficult and time-consuming, but it is definitely possible. Here are a few tips on how to break up a cast iron tub: 1. Use a hammer and chisel to break apart the cast iron tub. This is the most common way to break up a cast iron tub.

-A drill or chisel -Hammer -Pry bar

  • Use a hammer to knock pieces off the tub until it is in small enough pieces to remove
  • If there is any adhesive remaining, use a chisel to remove it
  • Use a wire brush to clean off the adhesive

-Use a claw hammer to gently pry the tub away from the wall. -Score around the tub with a utility knife. -Place a piece of wood between the tub and the wall and hit it with a sledgehammer. -Pry the tub apart with a crowbar.


Frequently Asked Questions

How Heavy Is An Old Cast Iron Tub?

The weight of an old cast iron tub can vary, but they are often quite heavy.

How Do You Remove An Old Cast Iron Tub?

Removing an old cast iron tub can be a difficult and labor-intensive process. First, the tub must be drained of all water. Next, the tub must be unscrewed from the bathroom floor or wall. Then, the tub must be lifted out of the bathroom. Finally, the tub must be transported to a landfill or recycling center.

How Much Do Old Cast Iron Tubs Weigh?

Cast iron tubs weigh a lot! Older tubs can weigh more than 300 pounds, while the newer, lightweight models weigh around 100 pounds.

Can You Cut Out A Cast Iron Tub?

Yes, you can cut out a cast iron tub but it is not an easy job. You will need to use a sawzall or a reciprocating saw to cut through the cast iron.

How Do You Break A Cast Iron Tub?

Cast iron bathtubs are heavy and durable but they can also be difficult to remove if they are installed properly. One way to break a cast iron tub is to use a hammer and chisel to chip away at the mortar around the tub. Once the mortar is removed, the tub can be pried loose with a crowbar.

Can You Break Cast Iron Tub?

Yes, you can break a cast iron tub if you use enough force.


In Summary

Cast iron tubs are extremely heavy and difficult to move. If you are wanting to break up a cast iron tub, it is best to use a sledgehammer or axe to do so. Be sure to wear protective gear, as there will be shards of metal flying in all directions.

Leave a Comment

Your email address will not be published.