How To Change S Trap To P Trap

Changing a sink trap from a S-trap to a P-trap is a relatively easy plumbing project that can be completed in a few hours. The main difference between the two traps is that the P-trap has a horizontal pipe, while the S-trap has a vertical pipe. The following steps can be used to change a sink trap: 1. Turn off the water supply to the sink. 2. Disconnect the drainpipe from the sink and remove the old trap

How To Change S Trap To P Trap

The process of converting a s-trap to a p-trap is a fairly simple one. First, remove the existing s-trap and disconnect it from the drainage pipe. Next, cut a piece of p-trap that is the same length as the drainage pipe. Finally, reconnect the p-trap to the drainage pipe and reattach the sink’s drain hose.

– adjustable wrench – channel locks – hacksaw – metal snips – Teflon tape

  • Trap and discard
  • Thread the p
  • Remove the slip nuts from the old s
  • Trap onto the tailpiece until it is hand tight attach the slip nuts to the ptrap and tighten turn on the water

below -Measure the distance from the floor to the drain opening on the sink. -Purchase a p-trap that is the same length as the measurement you took. -Remove the old s-trap by unscrewing it from the sink and drain opening. -Thread the new p-trap onto the sink and drain opening. Tighten with a wrench if needed. -Make sure that the p-trap is inserted into the drain pipe far enough so that the


Frequently Asked Questions

Are S-Traps Legal In Canada?

S-traps are legal in Canada.

Why Are S Traps Not Allowed Anymore?

S traps were not allowed anymore because they were inefficient and did not work well. They also posed a threat to the environment and could release harmful gases into the air.

Is P-Trap Better Than S-Trap?

There is no definitive answer to this question as both P-traps and S-traps have their own advantages and disadvantages. Some people might find that P-traps are better because they are easier to clean, while others might find that S-traps are better because they are less likely to clog. Ultimately, it is up to the individual to decide which trap is better for them.


Wrap-Up

There are a few ways to change a s-trap to a p-trap. The first way is to cut the pipe below the sink, remove the s-trap, and install a p-trap in its place. The second way is to cut the pipe above the sink, remove the s-trap, and install a p-trap in its place. The third way is to cut the pipe below the sink, remove the s-trap, and install a piece of pipe that has been threaded on both ends. The fourth way is to cut the pipe above the sink, remove the s-trap, and install a piece of pipe that has been threaded on both ends.

Leave a Comment

Your email address will not be published.