How To Change The Blade On A Ridgid Miter Saw

The Ridgid Miter Saw has a detachable blade that can be easily replaced. To replace the blade, first remove the saw’s power cord from the electrical outlet. Next, remove the saw’s dust bag and then use a hex key to remove the four screws that secure the saw’s base to the saw’s arm. After removing the base, use a socket wrench to remove the two screws that secure the blade guard to the saw’s arm. Finally, use a screwdriver to

How To Change The Blade On A Ridgid Miter Saw

Changing the blade on a Ridgid miter saw is a quick and easy process. The first step is to remove the saw blade guard by pressing the release button and pulling it down. Next, loosen the blade bolt by turning it counterclockwise with a wrench. Finally, pull the old blade off and replace it with a new one. Make sure to tighten the blade bolt before replacing the saw blade guard.

– a ridgid miter saw – a T-bar hex key – a 10mm socket – a ratchet – an adjustable wrench – a new blade

  • Remove the blade by pulling it towards you
  • Unplug saw from power source
  • Open saw arm and remove blade guard
  • Remove the blade bolt by turning it counterclockwise

-Check the saw’s manual to see what type of blade is recommended -Shut off the saw and unplug it from the outlet -Loosen the bolts that hold the blade in place -Remove the old blade and replace it with a new one -Tighten the bolts to hold the blade in place


Frequently Asked Questions

How Do You Change A Saw Blade On A Ridgid Miter Saw?

There is a wing nut on the back of the saw that you loosen to slide the blade out. There are several ways to secure the new blade in place, depending on the model of saw.

Which Way Do You Put A Blade On A Circular Saw?

The correct way to put a blade on a circular saw is to make sure that the teeth of the blade are facing downwards.

How Do You Put A Blade In A Ridgid Circular Saw?

To put a blade in a ridgid circular saw, first make sure the saw is unplugged. Then open up the housing of the saw by removing the screws that hold it together. Lift the top of the housing off and set it aside. Remove the old blade by unscrewing the retaining bolt and pulling the blade out of the saw. Make sure that the teeth of the new blade are facing forward before installing it. Insert the new blade into the saw and reattach the retaining bolt. Replace the top of the housing and screw it back on. Plug in the saw and test it out.


To Review

There are a few ways that you can change the blade on your Ridgid miter saw. The first way is to remove the shroud, which is the cover that goes over the blade. The second way is to loosen the bolt that holds the blade in place. The third way is to use a wrench to hold the arbor nut in place while you loosen the bolt.

Leave a Comment

Your email address will not be published.