How To Clean Outboard Carb

An outboard carburetor needs to be cleaned every so often to ensure that it continues to run smoothly. There are a few different ways to clean an outboard carb, but the most common is to use a carburetor cleaner and a brush.

How To Clean Outboard Carb

Outboard carburetors are notorious for being difficult to clean. The best way to clean an outboard carb is to remove it from the engine and soak it in a carburetor cleaner solvent. Be sure to read the manufacturer’s instructions before using any type of solvent.

– a screwdriver – a bowl – a can of carb cleaner – a rag

  • Remove the air filter and housing
  • Remove the carburetor from the engine flush the carburetor with carb cleaner spray all of the internal
  • Disconnect the fuel line and remove the gas tank

below -If the engine is still warm, turn off the ignition, remove the spark plug and pour a small amount of oil into the cylinder. -Replace the spark plug and turn the engine over several times by hand. -Now remove the air cleaner and spray carburetor cleaner inside the carb throat while holding the carburetor cleaner can upside down. -Replace the air cleaner and start the engine. Let it run until it dies.


Frequently Asked Questions

What Is The Best Carburetor Cleaner For A Outboard Motor?

There is no definitive answer to this question since different carburetors may respond differently to different cleaners. However, in general, a cleaner that is designed for two-cycle engines – such as outboard motors – will be most effective.

How Do You Clean High Speed Jets On An Outboard Motor?

To clean high speed jets on an outboard motor, you can use a spray cleaner and a brush. First, spray the cleaner onto the jets and let it sit for a few minutes. Then, use a brush to scrub away any dirt or build-up. Finally, rinse the jets with water and let them air dry.

How Do You Clean A Clogged Pilot Jet?

There are a few ways to clean a clogged pilot jet, but the most common is to use a wire. You can either use a wire coat hanger or a wire brush.


In The End

uretors Before cleaning the carburetor, read the owner’s manual to find out the specific procedures for your make and model. Some general tips include: -Disconnect the spark plugs to prevent accidental starting -Remove the air cleaner assembly -Drain any fuel from the carburetor bowl -Spray a carburetor cleaner or other solvent inside the carburetor and let it soak for a few minutes -Scrub any built-up deposits with a brush -Rinse off all the cleaning solution with fresh water -Reattach the air cleaner assembly and reconnect the spark plugs -Start the engine and check for proper performance

Leave a Comment