How To Cut Orangeburg Pipe

Orangeburg pipe is a type of pipe made from cellulose acetate butyrate, a type of plastic. It is used to carry water, gas, and other fluids. Orangeburg pipe is often used in plumbing systems because it is resistant to corrosion and can withstand high pressures. It is also relatively inexpensive and easy to install.

How To Cut Orangeburg Pipe

There is no one definitive way to cut Orangeburg pipe. Some possible methods include using a hacksaw, PVC cutter, or circular saw.

-Tape Measure -Pipe Cutter -Marker -Safety Glasses

  • Use a utility knife to score the pipe and then snap it in two
  • Using a hacksaw, cut the orangeburg pipe to the desired length
  • Discard the damaged or unused portions of the pipe

below – first, ensure that the pipe is clean and free of debris – use a hacksaw to cut the pipe – be sure to cut along the pipe’s natural seams for a clean cut – cut the pipe slightly longer than needed so that it can be trimmed to fit


Frequently Asked Questions

What Is The Outside Diameter Of 4 Inch Orangeburg Pipe?

The outside diameter of 4 inch Orangeburg Pipe is approximately 4.5 inches.

What Is The Outside Diameter Of A 4 Inch Cast Iron Pipe?

The outside diameter of a 4 inch cast iron pipe is 4.5 inches.

What Is The Outside Diameter Of Cast Iron Pipe?

The outside diameter of cast iron pipe can vary, but typically ranges from 3.5 to 10 inches.


Wrap-Up

There are a few ways to cut orangeburg pipe. One way is to use a hacksaw with a fine tooth blade. Another way is to use a circular saw with a fine tooth blade.

Leave a Comment

Your email address will not be published.