How To Install A Rear Flush Toilet

If you are considering installing a rear flush toilet in your home, there are a few things you will need to know before beginning the installation process. The most important factor to consider is the location of the drain pipe. The drain pipe for a rear flush toilet should be located behind the toilet, as opposed to in front of it like a traditional toilet. In addition, you will need to purchase a special flushing mechanism designed for rear flush toilets. Once you have determined the location of

How To Install A Rear Flush Toilet

Installing a rear flush toilet is a fairly simple process that can be completed in a few hours with the right tools and materials. The first step is to remove the old toilet and disconnect the water supply. The new toilet should then be positioned in the desired location and leveled before being attached to the flange. Finally, the water supply line can be reconnected and the toilet tested for leaks.

a. Rear flush toilet b. Plumber’s putty c. Tape measure d. Level e. Pencil f. Drill g. Hole saw h. Jigsaw i. Chisel j. Hammer k. Pry bar l. Caulking gun m. Silicone sealant n. Clean rag

  • Remove the old toilet by disconnecting the water supply and removing the bolts that hold it in place
  • Measure and mark the location of the flange on the floor
  • Locate the rear flush toilet that you want to install

-Check that the water supply is off -Open the tank and remove the old toilet seat and wax ring -Clean the area where the toilet will be installed with a degreaser -Apply plumber’s putty around the base of the flange -Set the toilet in place and press down on it to create a seal with the putty -Screw in the bolts that come with the toilet -Connect the water supply and


Frequently Asked Questions

What Is A Back To Back Toilet Installation?

A back-to-back toilet installation is a plumbing configuration in which two toilets share a single drain and wastewater treatment system. This type of installation can be used when space is limited or when it is not possible to install the toilets on separate walls.

How Does A Power Flush Toilet Work?

A power flush toilet system uses a pump to push water and cleaning solution through the plumbing and into the toilet bowl. This high-pressure cleaning flushes away any dirt or debris, leaving the bowl clean and fresh.

How Long Do Power Flush Toilets Last?

The average lifespan of a power flush toilet is around 10 years. However, this can vary depending on the quality of the unit and how often it is used.

What Is Toilet Trapway?

The toilet trapway is the part of the toilet that traps water and waste inside the bowl so it can be flushed away. The trapway is typically made up of two parts: the S-shaped curve at the bottom of the bowl and the flange, which sits against the floor and connects to the drain pipe.

How Does A Back Outlet Toilet Work?

A back outlet toilet works by the water flowing from the tank and through the bowl and then out the back of the toilet. This is opposed to a front outlet toilet where the water flows from the bowl to the tank.

What Is A Backflush Toilet?

A backflush toilet is a type of flushing toilet that uses water to flush waste away, and then uses a siphon to suck the wastewater away from the toilet. This type of toilet is often used in commercial settings, as it is more efficient than traditional flushing toilets.


In Closing

Installing a rear flush toilet is a relatively easy process that can be completed in just a few hours. The first step is to remove the old toilet and flange from the floor. The new toilet and flange can then be installed, and the toilet can be hooked up to the water and plumbing lines. Finally, the toilet seat and lid can be installed.

Leave a Comment

Your email address will not be published.