How To Make Epoxy Clear After Sanding

There are a few ways to make epoxy clear after sanding. One way is to use a primer before applying the epoxy. Another way is to use a lacquer or shellac over the epoxy.

How To Make Epoxy Clear After Sanding

There are a couple of things you can do to make epoxy clear after sanding. You can use a sanding sealer, which will help to fill in any scratches and make the surface smoother. You can also use a clear coat over the epoxy to protect it and give it a glossier finish.

The following tools and materials are needed to make epoxy clear after sanding: -Epoxy resin and hardener -Masking tape -Paintbrush -220 grit sandpaper -Dust mask -Safety goggles

  • Begin by mixing the resin and hardener together in the desired proportions
  • Then apply the epoxy mixture to the surface that needs to be repaired
  • After the epoxy has been applied, use a sandpaper or other abrasive

-When sanding epoxy, always wear a dust mask to avoid breathing in the particles. -After sanding, use a damp cloth to wipe away any remaining dust or debris. -Then, apply a coat of epoxy sealer to protect the surface and keep it looking clear.


Frequently Asked Questions

How Do You Make Epoxy Resin Clear Again?

There are a few ways to make epoxy resin clear again. One is to add a chemical called acetone to the resin. Another is to use a UV light to cure the resin.

What Can I Use To Shine Resin?

There are a few different ways that you can shine resin. One way is to use a high-quality polish. Another way is to use a wax. Finally, you can use a sealant.

How Do I Get A Clear Epoxy Finish?

To get a clear epoxy finish, you need to mix the epoxy resin and hardener together according to the manufacturer’s instructions. You can then brush or spray it on to your desired surface.

Why Isnt My Epoxy Clear?

There could be a few reasons why your epoxy isn’t clear. One reason may be that you didn’t mix the epoxy properly. Make sure to mix the resin and hardener thoroughly before using. Another reason may be that you didn’t use a primer before applying the epoxy. A primer will help the epoxy adhere better to the surface and will result in a more clear finish.

How Do You Get Epoxy Clear After Sanding?

The simplest way to get epoxy clear after sanding is to use a lacquer thinner. You can either spray it on or dip the piece into it.


In Closing

Epoxy can be made to be clear after sanding by using a certain type of resin and a certain amount of hardener. The resin and hardener should be mixed in the correct proportions, and then the epoxy should be allowed to cure for the correct amount of time.

Leave a Comment

Your email address will not be published.