How To Move A Shower Drain In Concrete

If you are looking to move a shower drain in concrete, you will need to use a jackhammer to break up the concrete and a shovel to remove the pieces. You will then need to use a drill to make the hole bigger so that the drain can fit. Once the drain is in place, you will need to use concrete mix to fill in the hole around the drain.

How To Move A Shower Drain In Concrete

There are a few ways to move a shower drain in concrete. One way is to use a jackhammer to break up the concrete around the drain and then pry it up with a crowbar. Another option is to use a chisel and hammer to break away the concrete around the drain until it’s loose enough to lift out. A third option is to use a power drill with a chisel bit to drill around the edge of the drain until it’s loose, and then pry

-Shovel -Trowel -Concrete chisel -Hammer -Safety glasses -Dust mask -Work gloves -Wire brush

  • Pry out the old drain with a chisel and hammer clean out any old concrete
  • Use a drill and hole saw to cut through the concrete around the drain
  • Mark the drain location on the concrete with a chalk line

-If the shower drain is located in a concrete slab, it can be moved by breaking out the concrete around it and cutting new holes in the slab. -Once the old drain is removed, the new one can be installed and the concrete repaired. -Be sure to use a waterproof sealant around the new drain to prevent leaks.


Frequently Asked Questions

How Do You Move A Cast Iron Shower Drain In Concrete?

The easiest way to move a cast iron shower drain in concrete is by using a jackhammer.

How Much Does It Cost To Reroute Plumbing In Slab?

The cost to reroute plumbing in slab will vary depending on the size of the project, the type of materials used, and the contractor you hire. However, you can expect to pay anywhere from $1,000 to $10,000 for a standard plumbing reroute.

Can You Move Plumbing On A Concrete Slab?

Yes, it is possible to move plumbing on a concrete slab. However, it is important to take into account the weight of the plumbing and the structural integrity of the slab when planning the move. If the plumbing is not properly supported, it could cause damage to the slab or to the plumbing itself.


In Closing

If you are moving a shower drain in concrete, the process is relatively simple. First, use a drill to make a hole in the concrete where the shower drain will be located. Next, use a chisel to rough up the edges of the hole. Finally, insert the shower drain and seal it in place with silicone caulk.

Leave a Comment

Your email address will not be published.