How To Put A Spigot On A 55 Gallon Drum

A spigot is a type of valve that can be attached to a container to allow liquid or gas to flow out. They are typically made of brass, steel, or plastic. In order to put a spigot on a 55 gallon drum, you will need to first determine the size of the hole that needs to be drilled. The standard size for a spigot is 1/2 inch, so you will need to drill a hole that size in the side of the drum

How To Put A Spigot On A 55 Gallon Drum

There are a few ways to put a spigot on a 55 gallon drum. The most common is to use a bung adapter. This is a piece of hardware that screws into the bung hole on the top of the drum and has a spigot attached. Another way is to use a threaded coupling. This is a piece of hardware that screws onto the threads on the top of the drum and has a spigot attached.

-Drill -1 inch hole saw -Spigot -Tape measure -Permanent marker -Ruler or a straight edge -Sharpie -Screwdriver -Hacksaw

  • Using a hole saw or pipe cutter, cut a hole in the top of the drum. the size of the hole will depend on the size of the spigot you are using. 2.clean off any burrs or

– first, check that the drum is empty and clean – find the point on the drum where you want to install the spigot – use a drill to make a hole that is big enough for the spigot to fit snugly – insert the spigot and tighten the nut on the underside – fill up your drum with water and test out your new spigot!


Frequently Asked Questions

How Do You Seal A Rain Barrel Spigot?

There are a few ways to seal a rain barrel spigot – some people use plumber’s putty, others use Teflon tape. Whichever way you choose, make sure that the seal is tight so that water doesn’t leak out.

What Are The Parts Of A Rain Barrel?

Parts of a rain barrel usually include a spigot, screened opening, collection trough, overflow hose, and rain diverter.

How Do You Drill Holes In Plastic?

There are a few ways to drill holes in plastic. The most common is to use a drill bit and a power drill. Another way is to use a soldering iron.

How Do You Put A Valve On A Barrel?

There are a few different ways to put a valve on a barrel, but the most common way is to use a welding machine. You first need to measure and mark where the valve will go on the barrel. Then, you need to use the welding machine to weld the valve in place.

How Do You Make A Hole In A Plastic Drum?

There are a few ways to make a hole in a plastic drum. One way is to use a drill. Another way is to use a saw.

How Do You Install A Water Spigot On A 55 Gallon Drum?

Drill a hole on the upper part of the barrel and install the spigot. Make sure that the hole is big enough to fit the spigot’s threads. Tighten the spigot with a wrench. You may need to use a sealant to create a watertight seal.


In Closing

There are many ways to put a spigot on a 55 gallon drum. The way you choose will depend on the type of spigot you have, and the type of drum you are using.

Leave a Comment

Your email address will not be published.