How To Put Posts In The Ground For A Deck

One way to secure posts for a deck is to put them in the ground. This can be done with a post hole digger or by renting an auger. The hole should be about twice the width of the post and at least as deep as the post is tall. The bottom of the hole should be filled with gravel, then the post can be set in place and the concrete poured around it.

How To Put Posts In The Ground For A Deck

There are a few ways to secure posts in the ground for a deck. One way is to use concrete footings. Another is to bury the posts in concrete and use metal post anchors. Another way is to use patio blocks as footings and set the posts on top of them.

-Post hole digger -Shovel -Hammer -Tape measure -Level -Chalk line -Circular saw or handsaw -Construction adhesive -Cordless drill -1 inch hole saw -Paint or a sealant -Stakes -Rope

  • Set the post in the hole and fill around it
  • Dig a hole for each post that is about twice the diameter of the post and as deep as the frost line
  • Mark the location of the posts with spray paint or stakes

– posts should be placed in the ground at least 12 inches deep – posts should be spaced no more than 6 feet apart – post holes should be dug at a 45 degree angle – concrete should be poured in the hole around the post before setting it in place – use a level to make sure the post is straight before attaching the deck boards


Frequently Asked Questions

How Do I Secure My Deck Posts In The Ground?

To secure deck posts in the ground, use a post anchor. They come in different sizes to fit different sized posts, and can be hammered into the ground. There are also versions that can be attached to a concrete slab.

How Deep Should Deck Posts Be Grounded?

Posts should be buried at least 36 inches in the ground, with 8-10 inches of concrete at the bottom.

Should Deck Posts Be In The Ground?

There is no one right answer to this question. Some people prefer to have deck posts in the ground, as it can provide more stability for the deck. However, others find that it is easier and less expensive to simply anchor the deck posts to the top of the foundation or slab.


To Summarize

To put posts in the ground for a deck, start by measuring out where each post will go and marking the spot with a stake. Dig a hole at each mark, making sure to dig deep enough so that the post will be fully buried. Add some gravel to the bottom of each hole, then set the post in place and fill in around it with more gravel. Use a level to make sure each post is straight, then use screws or nails to attach the deck boards to the posts.

Leave a Comment

Your email address will not be published.