How To Remove Delta Shower Handle

Removing a delta shower handle can be a little tricky, but with a little patience it can be done. First, you will need to remove the screw that holds the handle in place. This is usually located on the underside of the handle. Once the screw is removed, you should be able to pull the handle off. If it is stuck, you may need to use a screwdriver to pry it off. Once the handle is off, you can unscrew the retaining nut that

How To Remove Delta Shower Handle

There is no one definitive answer to this question since the process of removing a delta shower handle can vary depending on the specific model and configuration of the showerhead. However, some basic steps that may be useful for removing a delta shower handle include locating the screws or bolts that hold the handle in place and removing them, then gently pulling on the handle until it comes loose. It is also important to be aware of any water remaining in the showerhead before beginning this process, as this can cause

-Screwdriver -Channel locks -Pliers -Wrench -Allen wrench

  • If the washer is still in place, remove it by prying it off
  • Gently pull the handle straight off its shaft
  • Remove the screw at the base of the shower handle with a phillips head screwdriver

-Check the screws holding the handle in place. There may be two screws on the underside of the handle that need to be loosened before the handle can come off. -Look for a set screw on the top of the shower valve that holds the showerhead in place. This set screw will need to be loosened before the showerhead can be removed. -If there is calcium buildup on the shower valve, use a vinegar and water solution to clean it off before attempting to


Frequently Asked Questions

How Do You Get A Stripped Screw Out Of A Faucet Handle?

There are a few ways to get a stripped screw out of a faucet handle. One is to use a drill and drill bit the same size as the screw. Another is to use a screw extractor.

How Do You Remove A Delta Lever Shower Handle?

To remove a Delta lever shower handle, unscrew the set screw located on the side of the handle with a Phillips head screwdriver. Pull the handle straight off to remove. To reinstall, line up the tabs on the handle with the slots on the valve and push down until it snaps into place. Screw in the set screw until it is tight.

How Do You Remove A Delta Shower Handle With A Stripped Screw?

The Delta shower handle with a stripped screw can be removed by using a screwdriver to unscrew the handle from the shower arm. If the screw is too damaged to be unscrewed, the handle can be removed by breaking it free from the arm with a hammer and chisel.


To Review

Replacing a delta shower handle is a fairly simple process that can be completed in a few minutes. First, remove the screws from the escutcheon with a screwdriver. Next, pry off the escutcheon with a flathead screwdriver. Then, remove the handle screw and pull the handle off of the faucet. Finally, reattach the new handle and escutcheon and reattach the screws.

Leave a Comment

Your email address will not be published.