How To Remove Soldered Copper Pipe

Removing solder from copper pipe is a process that can be accomplished with a few simple tools. First, the pipe must be cleaned of any debris or oxidation. Next, a heat source is applied to the solder until it liquefies. Finally, the solder can be removed from the pipe using a plunger or wire brush.

How To Remove Soldered Copper Pipe

Removing a copper pipe that has been soldered in place can be a difficult task. There are a few methods that can be used to remove the pipe, but each method has its own risks and drawbacks. One method for removing a soldered copper pipe is to use a propane torch. The torch can be used to heat up the solder until it liquefies. The liquefied solder can then be poured out of the joint and the pipe can be removed. This

-copper pipe -soldering flux -solder -heat gun or propane torch -tin snips -pipe wrench -sandpaper

  • Use a file or sandpaper to clean any sharp edges on the copper pipe use a wrench to loosen the compression
  • Remove the valve from the copper pipe
  • Use a hacksaw to cut the copper pipe near the valve

– identify the location of the copper pipe you want to remove – use a pipe cutter to cut the copper pipe near the solder joint – use a screwdriver or pliers to remove the old solder from the pipe – use a soldering iron to heat the solder joint and melt the new solder onto the pipe – wait for the solder to cool and solidify before using the pipe


Frequently Asked Questions

Can You Resweat Copper Fittings?

It is possible to reseat copper fittings using a propane torch and flux, but it is not a recommended method.

Can You Unsolder A Pipe?

Yes, you can unsolder a pipe with a soldering iron.

How Do You Unsweat Copper Pipes?

There are a few ways to unsweat copper pipes. One way is to use a hair dryer on the cool setting and hold it about 6 inches away from the pipe. You can also use a fan or an air conditioning unit.

How Do You Unweld Copper?

You can use a torch to unweld copper. You need to heat the copper until it is red hot and then use a chisel or a hammer to break the copper apart.


Summing-Up

Removing a soldered copper pipe can be a difficult and frustrating process. However, with the right tools and patience, it can be done.

Leave a Comment

Your email address will not be published.