How To Tile Inside Corners

Tile inside corners can be tricky, but with a little practice it becomes easy. The key is to use a level and make sure the tiles are straight before you start. You can also use a tile spacers to help keep the tiles even.

How To Tile Inside Corners

There are a few ways to tile inside corners. One way is to use a trim piece, which is a small piece of tile that is cut to fit the corner and then attached with thinset mortar. Another way is to use a beveled edge tile, which has a sloped edge that allows it to fit into a corner. Finally, you can also use a bullnose tile, which is a tile that has a curved edge that can be used to create an inside

– A level – Chalk line – Square – Trowel – Notched trowel – Grout float – Grout sponge – Bucket – Rubber gloves – Safety glasses

  • Draw a level line on the wall at the height you want the tiles to be
  • Starting at one end of the wall, measure and mark the center of the first tile
  • Transfer the measurement to the wall and make

-Clean the surfaces to be tiled. Make sure all dirt, dust, and grease is removed. The tiles will not adhere well to a dirty surface. -Lay out the tiles according to your design. This will help you determine how many tiles you will need and where the inside corners will fall. -Measure the distance from the edge of one tile to the edge of the next tile. This is called the “joint.” -Determine the “joint


Frequently Asked Questions

Do You Start In The Corner When Tiling?

There is no right or wrong answer to this question as it depends on personal preference. Some people find it easier to start in the corner when tiling, as it gives them a guide to work from. Others prefer to start in the middle of the wall or floor, as they find it more manageable that way. Ultimately, it is up to the individual how they choose to start tiling.

How Should Tile Meet In A Corner?

Tile should meet at a 90 degree angle in a corner.

Do You Overlap Tiles In Corners?

There is no right or wrong answer to this question as it is simply a personal preference. Some people do overlap tiles in corners while others do not. Ultimately, whichever way you feel creates the most aesthetically pleasing look is the way to go.


In Closing

In order to tile inside corners, you will need to cut the tiles at a 45-degree angle. You can use a wet saw to do this, or you can use a sharp knife. Once the tiles are cut, you will need to apply mortar to the back of the tiles and then press them into place.

Leave a Comment

Your email address will not be published.